Ford Flush Fit Retractable Tie Down Anchors - ’15+ Ford F-150 | ’17+ Ford Super Duty | ’17+ Ford Raptor
Bull Ring’s are the premium tie-down anchor point for your truck. While the stock anchors points are inside the bed where it’s hard to reach, Bullrings retractable anchor points easily install into the stake pockets on top of your bed rails. Simply snap the stainless steel ring up when you want to use it to secure a load, then snap it down flush when you don’t. Each is made from stainless steel for a 1000 lbs capacity, matches the exact grain and color of Ford railcaps, and comes with our "no bull" Lifetime Warranty. Sold as a pair.
This anchor model is needed for certain Ford truck beds that have offset stake pockets in the front & middle locations, and standard stake pockets in the rear (by the tailgate). Rather than being perfectly centered in the plastic, these stake pockets are offset to one side in the railcap.
Our Flush model sits in line with the railcaps for a flush, clean look. and makes them compatible with Tonneau covers. Installation is quick and easy, and requires nothing more than a Phillips head screwdriver. Typical install time - Under a minute.
Models Available
4025 – Fits in the Front, Middle, or Rear Stake Pockets
4035 (Offset) – Certain trucks have stake pockets in the front that are ‘offset’ from the plastic rail cap (see picture). If you have this on your truck, purchase this 4035 for the front stake pockets (near the window).
Bull Ring’s are the premium tie-down anchor point for your truck. While the stock anchors points are inside the bed where it’s hard to reach, Bullrings retractable anchor points easily install into the stake pockets on top of your bed rails. Simply snap the stainless steel ring up when you want to use it to secure a load, then snap it down flush when you don’t. Each is made from stainless steel for a 1000 lbs capacity, matches the exact grain and color of Ford railcaps, and comes with our "no bull" Lifetime Warranty. Sold as a pair.
This anchor model is needed for certain Ford truck beds that have offset stake pockets in the front & middle locations, and standard stake pockets in the rear (by the tailgate). Rather than being perfectly centered in the plastic, these stake pockets are offset to one side in the railcap.
Our Flush model sits in line with the railcaps for a flush, clean look. and makes them compatible with Tonneau covers. Installation is quick and easy, and requires nothing more than a Phillips head screwdriver. Typical install time - Under a minute.
Models Available
4025 – Fits in the Front, Middle, or Rear Stake Pockets
4035 (Offset) – Certain trucks have stake pockets in the front that are ‘offset’ from the plastic rail cap (see picture). If you have this on your truck, purchase this 4035 for the front stake pockets (near the window).
