Belt Minders - Universal - Bestop Premium Accessories Group

When your belts are wrapped around the harness bar, they have a tendency to slide all over. PRP belt minders keep both shoulder belts together on the bar. It stops them from sliding apart, and provides better safety in case of an accident. The belt minder should be located behind the back of the seat (in-between the seat and the harness bar). Easiest to install by unwrapping each shoulder belt from the bar, running it through the minder, and then reattaching the shoulder belt to the bar.
PRP Belt Minders Keep Your Harness Straps Close Together and Keep You Safer
Sold as a Pair
WARNING: Proper installation and consistent use of restraint system is critical to your safety in event of accident. To reduce risk of serious injury or death, follow vehicle manufacturers, and PRP installation instructions and safety messages during installation and use of this product. Use all belts provided. Secure lap belt first; low and snug across hips. Sternum strap tight at chest line (min. 4 in. below the neck). Adjust remaining straps per instructions and confirm fitment restrains user and provides safe clearance from wheel, dash, roll cage, etc. Inspect all components of the harness restraint system regularly and replace as indicated by accident, wear, or abrasion. Replace no later than 2 years from the date on SFI tag, or purchase. This restraint system is intended for UTV or other off-road vehicle - not replacement for FMVSS 209 restraints. Never use with child car seats or boosters.
Universal

Belt Minders - Universal